D Set The Operation Frq. For Ic-F11Br - Icom IC-F11BR Instruction Manual

4
SET MODE
D D IC-F11BR (VHF) SETTING THE OPERATION FREQUENCY
The operating frequency can be selected from 36 frequencies. (See
right.) Select the frequencies you desire from the frequency table
and assign them to CH 1 and CH 2.
• Default settings are as follows;
CH 1: Operating CH No. 1 (154.5700 MHz), CTCSS: No. 0 (OFF)
CH 2: Operating CH No. 2 (154.6000 MHz), CTCSS: No. 0 (OFF)
q While pushing and holding [PTT], [MONI] and [W/N], turn
[OFF/VOL] to power ON.
w Select the desired CH 1 or CH 2 that you want to assign the fre-
quency to.
e Push and hold [W/N] until a beep (Pi) is emitted.
r Push [PTT] the necessary number of times to choose the 10 digit
of the desired channel from the channel list.
t Push [MONI].
y Push [PTT] the necessary number of times to choose the 1 digit
of the desired channel from the frequency list.
u Push [MONI].
i Turn the power OFF, and then ON again.
[Example]
To assign Frequency channel No. 28 as CH1;
q While pushing and holding [PTT], [MONI] and [W/N], turn
[OFF/VOL] to power ON.
w Select the CH 1.
e Push and hold [W/N] until a beep (Pi) is emitted.
r Push [PTT] twice to choose the 10 digit of the desired channel.
t Push [MONI].
y Push [PTT] eight times to choose the 1 digit of the desired chan-
nel.
u Push [MONI].
i Turn the power OFF, and then ON again.
13