Table of Contents
Advertisement
4
SET MODE
D D IC-F21BR (UHF) SETTING THE OPERATION FREQUENCY
The operating frequency can be selected from GMRS ( Plus 7 fre-
quencies shared with FRS) and BRS frequencies. (See right.)
Select the frequencies you desire from the frequency table and as-
sign them to CH 1 and CH 2.
• Default settings are as follows;
CH 1: Operating CH No. 1 (464.5500 MHz), CTCSS: No. 0 (OFF)
CH 2: Operating CH No. 2 (467.9250 MHz), CTCSS: No. 0 (OFF)
q While pushing and holding [PTT], [MONI] and [W/N], turn
[OFF/VOL] to power ON.
w Select the desired CH 1 or CH 2 that you want to assign the fre-
quency to.
e Push and hold [W/N] until a beep (Pi) is emitted.
r Push [PTT] the necessary number of times to choose the 10 digit
of the desired channel from the channel list.
t Push [MONI].
y Push [PTT] the necessary number of times to choose the 1 digit
of the desired channel from the frequency list.
u Push [MONI].
i Turn the power OFF, and then ON again.
[Example]
To assign Frequency channel No. 28 as CH1;
q While pushing and holding [PTT], [MONI] and [W/N], turn
[OFF/VOL] to power ON.
w Select the CH 1.
e Push and hold [W/N] until a beep (Pi) is emitted.
r Push [PTT] twice to choose the 10 digit of the desired channel.
t Push [MONI].
y Push [PTT] eight times to choose the 1 digit of the desired chan-
nel.
u Push [MONI].
i Turn the power OFF, and then ON again.
15
Advertisement
Table of Contents
