Scan Operation; I Scan Operation - Icom IC-A110 Instruction Manual

I Scan operation

q Push [V/M] to select memory mode or VFO mode, if nec-
essary.
MR
• " " appears on the memory mode.
w Make sure the squelch level is set to the threshold point.
• Set a squelch level (01 to 25) where the noise is muted.
e Push [SCAN] to start scan.
• To change the scan direction, turn [DIAL].
• "SCAN (or P SCAN)" flashes while scaning.
r Push [SCAN] again to stop the scan.
NOTE: Normal scan or Priority scan is pre-programmed
by cloning. Please ask your dealer or system operator for
details.
ï NORMAL SCAN
•Memory lock scan
Repeatedly scans memory
channels except skip (lockout)
channels.
Mch 1
Mch 2*
SKIP
Mch 3
Mch 20
*: Lockout ch
250 msec.

SCAN OPERATION

• VFO scan
Repeatedly scans all
frequencies over the entire
band.
Scan step is minimum channel
spacing. (eg 25 kHz or 8.33*
kHz)
*Except USA version
ï PRIORITY SCAN
•Priority memory scan
While scaning on a memory
mode, priority watch checks
for a signal on the selected
priority channel every 250 m
sec except lockout channel.
3
lowest highest
Start
frequency frequency
Scan
Jump
250 msec.
250 msec.
Mch 1
Mch 2*
SKIP
Priority
ch
Mch 3
Mch 20
*: Lockout ch
6