I On-Hook Scan; I Dualwatch - Icom IC-A110 Instruction Manual

3
SCAN OPERATION
I On–hook scan
On–hook scan (Hanger scan) is available when taking the mi-
crophone from its hanger (off–hook) and /or returning it into
the hanger (on–hook).
q Push [SCAN] to start scanning.
w When receiving a signal, scan pauses until the signal dis-
appears.
➥
You can converse by taking the microphone from the
•
hook.
e Place the microphone on the hook to restart scanning.
r Scan restarts 2 sec. after the signal disappears even if you
did not converse the station.
When you take the microphone during the scan operation.
➥
In VFO scan; scan resumes promptly to frequency.
•
➥
In memory scan; scan resumes promptly to memory
•
➥
In priority memory scan; scan resumes to priority channel,
•
NOTE: Be sure to connect the supplied microphone
hanger to the vehicle's ground for on/off hook microphone
functions. (p. 12)
7
channel.

I Dualwatch

Dualwatch monitors priority channel while you are receiving
an other channel (VFO or memory channel).
• If a signal is received on pri-
ority channel, dualwatch
pauses on priority channel
until the signal disappears.
• To transmit on the selected
channel during dualwatch,
push and hold PTT.
ï ï Operation
q Select the desired operating channel (VFO or Memory
channel).
w Push and hold [PRI] for 1 sec. to start dualwatch.
'P' blinks during dualwatch.
e To cancel dualwatch, push [PRI] again.
250 msec.
5 sec.
VFO
frequency
Priority
or
channel
memory
channel