Drive Chain Lubrication - Yamaha AG200F Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
3. To tighten the chain, turn the
chain adjusting plates in direc-
tion a. To loosen the chain,
1
turn the chain adjusting plates
in direction b and push the
2
wheel forward.
chain adjusting plate exactly
3
the same amount to maintain
correct axle alignment. There
are marks on
4
adjusting plate.
marks to align the rear wheel.
5
cC
6
Too little chain slack will overload
the engine and other vital parts.
7
Keep the slack within the specified
limits.
8
4. After adjusting, be sure to
9 tighten the
sprocket shaft nut to the speci-
fied torque.
Tightening torque:
Turn each
5. Adjust the free play in the
each chain
brake pedal.
Use these
w
EC000096
Check the operation of the brake
light after adjusting the rear brake.
axle nut and
Axle nut:
85 Nm (8.5 m0kgf,
61.5 ft0kgf)
Sprocket shaft nut:
85 Nm (8.5 m0kgf,
61.5 ft0kgf)
6-20

Drive chain lubrication

The chain consists of many parts
which work with each other. If the
chain is not maintained properly, it
will wear out quickly. Therefore,
the chain must be serviced regular-
ly. This service is especially neces-
sary when riding in dusty areas.
1. The drive chain should be
lubricated every 500 km (300
EW000103
mi). First, remove all dirt and
mud from the chain with a
brush or cloth. Then, spray any
of the many brands of spray-
type chain lubricant between
both rows of side plates and
on all center rollers.
2. To clean the chain thoroughly,
remove it from the motorcycle,
dip it in solvent, and clean out
as much dirt as possible. Then,
take the chain out of the sol-
vent to dry it, and immediately
lubricate it to prevent it from
rusting.
EAU01106*