Automatic Start / Stop; Dual Pressure Filling Module - Paramina CYCLONE SILENT 24E User Manual

User Manual - Cyclone Silent -
3. Start filling by first turning on the filling hose lever valve (2) and then the one of the cylinder.
4. After filling is complete, first turn off the cylinder valve and then filling hose lever valve. Filling hose air
venting is done automatically when turning off the lever valve (through lever valve's side sintered filter).
5. Finally, safely disconnect the cylinder.
During the filling procedure, cylinder's temperature will rise. Let it cool down. Pressure will slightly drop. If you
wish, re-connect the cylinder with the filling hose (following the same procedure) and fill until the maximum filling
pressure.
Never turn on the lever filling valve, unless the cylinder is connected to the filling hose. In case of
mistake, hose whipping due to pressurized air is secured as the connector ends DIN200 & DIN300 (3) are
equipped with flow stop facility (air passes after the connector only if it is safely connected onto the cylinder
valve)
4.6. Automatic start / stop system
When the pressure reaches the pre-adjusted final level the compressor stops automatically {through the pressure
switches}. By changing the parameter M (menu P01, parameter 1, compressor mode – see page 22) from S (semi)
to F (full) automatic mode, both the stoppage and the restart of the compressor will be done automatically too.
Max. operating pressure 350 bar.

4.7. Dual pressure filling module

 Optional equipment.
It controls the pressure through the pressure switches and gives the possibility to the user to fill 200 and 300 bar
cylinders. By turning the key (1) on the left the user can fill at 225 bar max. pressure and by turning the same key
on the right, the user fills at 350 bar max. pressure.
PARAMINA SA – Byway Evaggelistrias str. 19300 Aspropirgos, Greece, Tel: 0030 210 5575860-1
Fax: 0030 210 5575868, email:
1-2018 edition
2
service@paramina.gr - website:
3
1
www.paramina-compressors.com
13