Oil Change - Paramina CYCLONE SILENT 24E User Manual

User Manual - Cyclone Silent -

6.5. Oil change

Change the oil after the first 20 operating hours and then every 500 hours.
Always check the oil level through the oil sight glass (1) before every start of the compressor. The level should
always be at the top of the sight glass (leaving a small air bubble at the top of the glass). While the compressor is
operating the level should be between the minimum and the maximum of the sight glass (red mark).
Oil change procedure:
1. Open the drain valve (2) and empty the oil vessel into a canister. After emptying the oil vessel close the valve.
2. Unscrew the plug (3) and pour new oil inside the compressor block (3,0* lit.), till the upper part of the oil sight
glass. Screw the plug (3) again at the same position.
3. Now you are ready to restart the compressor.
*The proper quantity of oil, when you replace it, is 3,0 lit for compressors with serial numbers after /
including the 1424012 (CYCL.24E), 1330067 (CYCL.30E) & 1336001 (CYCL.36E). All compressors with earlier
serial numbers must be filled with 2,7 lit oil.
.
1
New Version from serial numbers:
1424012 (CYCL.24) – 1430084 (CYCL.30) –
1436009 (CYCL.36)
PARAMINA SA – Byway Evaggelistrias str. 19300 Aspropirgos, Greece, Tel: 0030 210 5575860-1
Fax: 0030 210 5575868, email:
1-2018 edition
3
2
service@paramina.gr
1
Old Version up to serial numbers:
1324011 (CYCL.24) – 1430083 (CYCL.30) –
1436008 (CYCL.36)
- website: www.paramina-compressors.com
3
2
31