Table of Contents
Advertisement
and –8 also require a circuit
breaker or a time delay fuse rated
at 15 amps for the circuit being run
to them.
The LBN-10 requires conduit
connections of both 115v and 208-
230v with an amperage rating of 15
amps for each circuit. Marked
leads are provided for these
connections in the field.
If wiring the LBN-10 to a "3-wire"
system is preferred, a 20amp, 208-
230 v circuit needs to be provided.
See the diagram below concerning
a "3-wire" system.
All of these models are 60hz, 1ph.
If another voltage, hertz, or phase
is required, please consult the
factory.
IT IS VERY IMPORTANT TO
YOU AND YOUR CUSTOMERS
TO HAVE THE CABINET
PROPERLY GROUNDED. A
qualified electrician in accordance
with the National Electrical Code
and/or local codes should do the
electrical installation.
NOTE: Connecting this unit to
any electrical supply other than
specified on the serial plate will
void the warranty and may result
in serious damage to the unit. The
cabinet should be supplied with its
OWN service.
SERIAL PLATE INFO.
The serial plate is located on the
left-hand end of the case interior,
and a second one in the condensing
unit compartment. It has all the
pertinent information needed for
proper electrical installation. The
serial plate should not be removed
for any reason.
INITIAL START UP AND
LOADING
Set the defrost timer for the
correct time of day, making sure
the defrost pins are secure in
the face of the clock. The LBN-
4 through –8 models are
factory set for one (1) defrost
period in 48 hrs. @ 12 a.m. and
LBN-10 is factory set for one (1)
defrost period in 24 hrs. @ 12
a.m.
Check the cabinet thoroughly
for loose nuts and bolts and
electrical connections. Inspect
the refrigeration lines for any
visible damage or chafing.
Replace the louvered access
panel.
6
Hide quick links:
Advertisement
Table of Contents
