Table of Contents
Advertisement
P/N 9FQ-6-P110-075-00_B
MODEL DESCRIPTION
The MDN models are open, vertical, medium
temperature display merchandisers . They are
self contained merchandisers with their own
condensing unit . Each self contained model
has a condensing unit that is factory installed
beneath the display area of the case . The unit
is ready for operation when electrical service
is connected . See Section 2 for electrical
information before starting the case .
UNLOADING
Unloading from Trailer:
Lever Bar (also known as a Mule, Johnson
Bar, J-bar, Lever Dolly, or Pry Lever) Move
the merchandiser as close as possible to its
permanent location and remove all packaging .
Check for damage before discarding packaging .
Remove all separately packed accessories
such as kits and shelves . Improper handling
may cause damage to the merchandiser when
unloading . To avoid damage:
1 . Do not drag the merchandiser out of the
trailer . Use a Johnson bar (mule) .
2 . Use a forklift or dolly to remove the
merchandiser from the trailer .
SERIAL PLATE LOCATION
The serial plate is located at the interior top
left end . It contains all pertinent information
such as model, serial number, amperage rating,
refrigerant type and charge .
Serial Plate
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
EXTERIOR LOADING
Do NOT walk on top of merchandisers or
damage to the merchandisers and serious
personal injury could occur . Merchandisers are
not structurally designed to support excessive
external loading such as the weight of a person .
Do not place heavy objects or flammable
materials on the merchandiser .
SHIPPING SKID
Each merchandiser is shipped on a skid to
protect the merchandiser's base, and to make
positioning the case easier . Remove the top of
the crate, and detach walls from each other .
Lift crate from the skid . Unscrew the case
from the skid . The fixture can now be lifted
off the crate skid . Lift only at base of skid!
Remove any attached braces and/or skids .
DO NOT TILT MERCHANDISER ON ITS
SIDE OR END WHEN REMOVING SKID .
The case is equipped with casters for ease of
installation and transportation inside store .
Check floor where cases are to be set to see if
it is a level area . Determine the highest part of
the floor .
Do NOT remove shipping crate until the
merchandiser is positioned for installation.
THERMOMETER
The cabinet has a "pencil" type thermometer
and reads from -40º F to 120º F / -40º F to 50º F
on 2º increments . The thermometer is located
in the packout kit inside of the merchandiser .
It should be placed and left inside the bottom
front interior compartment during normal
operation of the merchandiser .
Open Vertical Merchandisers
1-5
Hide quick links:
Advertisement
Table of Contents
