Merchandiser Leveling; Serial Plate Location; Sealing Merchandiser To Floor - Hussmann MicroSC ISMGG2DA-A Installation & Operation Manual

1-6 INSTALLATION

MERCHANDISER LEVELING

B
e sure to position merchandisers
. Level the merchandiser by all four
properly
corners. Merchandiser(s) must be installed
level to ensure proper operation of the
refrigeration system, and to ensure proper
drainage of defrost water.

SERIAL PLATE LOCATION

The serial plate is located on the inside of the
merchandiser's display area near the return air.
NOTE:
Impacts from shopping carts can cause wood to wear,
cracks, chipping or peeling. To avoid these impacts, it
is required to install a floor bumper (or alike) around
the case or other type of protection to prevent damage
to the wood.
Serial Plate
P/N 3110586_A

SEALING MERCHANDISER TO FLOOR

If required by local sanitary codes, or if the
customer desires, merchandisers may be sealed
to the floor using a vinyl cove base trim.
The size needed will depend on how much
variation there is in the floor, from one end of
the merchandiser to the other. Sealing of the
lower front and rear panels on self contained
models may hamper their removal for servicing
or maintenance of the condensing unit.
NOTE:
Do not allow trim to cover any intake or discharge
grilles located in the lower front panel.
U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com