Table of Contents
Advertisement
LIGHTING
Cool white fluorescent bulbs
located on the underside of the
stainless steel mirror reflector
provide interior lighting. The
bulbs are sleeved to maintain
proper heat around the bulb for
maximum light intensity and to
protect the product in case of
breakage.
The tubes can be replaced
without removing the doors. To
replace, twist the bulb and slide
the prongs clear of the
lampholder. When reinstalling
this type of bulb be sure the
prongs on the bulb twist and
lock into place.
There is a convenient ON/OFF
switch located on the right hand
end, inside the cabinet, behind
the mirror reflector. This
switch only controls the lights.
The 115-volt power must be
shut off at the main power
supply source located within the
store prior to starting any
service or maintenance work.
The lights should always be left
on to prevent moisture from
forming on the mirror reflector,
which is especially possible in
high humidity applications.
The light ballast is located in
the light fixture. To gain access
remove the mirror reflector.
CONDENSATE HEATERS
There are condensate heaters
behind the stainless steel end
panels, around the front glass, and
behind the nose screen. These
heaters are thermostatically
controlled in case the cabinet
malfunctions and the thermostat
senses above 101
F at which time
o
the heaters will shut off. At
normal ambients and cabinet
operation the heaters will remain
on.
END PANEL HEATERS
The end panel heaters are located
behind the end panel stainless
steel reflectors. They can be
removed by removing the screws on
the bottom edge of the panel and
pulling down on the bottom edge.
The heater is on adhesive foil on
the backside of the panel.
13
Hide quick links:
Advertisement
Table of Contents
