Pycom WiPy 3.0 Manual page 465

8.3.2 Connect to Pybytes: Flash Pybytes library manually
{
"address": "PASTE_YOUR_SERIAL_PORT_HERE",
"username": "micro",
"password": "python",
"sync_folder": "flash"
}
5. Checkout your
flash/pybytes_config.json
from Pybytes Like deviceToken or WiFi credentials. You can change e.g. your WiFy
password here.
6. Put your device in safe boot mode.
7. Upload code to your device by clicking on Upload button in Pymakr. After all Pybytes
library files are uploaded to device, device will restart and will connect to Pybytes.
Pybytes library is written to
firmware libraries in
Next step: Set up your device's
dashboard!
Now it's time to display data from your device into Pybytes dashboard. You can check more
about it here!
folder and will take precedence over build in
/flash
folder.
/frozen
file. It will be pre-filled with your information
465