Table of Contents
Advertisement
1.1.1 FiPy
When using the expansion board with a FiPy, you will need to remove the CTS and RTS
jumpers as these interfere with communication with the cellular modem.
Look for the reset button on the module (located at a corner of the board, next to the
LED).
Locate the USB connector on the expansion board.
Insert the FiPy module on the Expansion Board with the reset button pointing towards
the USB connector. It should firmly click into place and the pins should now no longer
be visible.
Before connecting your module to a Pysense/Pytrack/Pyscan board, you should update
the firmware on the Pysense/Pytrack/Pyscan. Instructions on how to do this can be
found here.
Look for the reset button on the FiPy module (located at a corner of the board, next to
the LED).
Locate the USB connector on the Pysense/Pytrack/Pyscan.
Insert the module on the Pysense/Pytrack/Pyscan with the reset button pointing towards
the USB connector. It should firmly click into place and the pins should now no longer
be visible.
45
Advertisement
Table of Contents
Need help?
Do you have a question about the WiPy 3.0 and is the answer not in the manual?
Questions and answers