Pycom WiPy 3.0 Manual page 412

6.1.6 GPy
The datasheet of the GPy is available as a PDF File.
Notes
WiFi
By default, upon boot the GPy will create a WiFi access point with the SSID
where is a random 4-digit number, and the password
XXXX
The RF switch that selects between the on-board and external antenna is connected to
, for this reason using
P12
application.
Power
The pin on the GPy can be supplied with a voltage ranging from
Vin
pin on the other hand is output only, and must not be used to feed power into the
3.3v
GPy, otherwise the on-board regulator will be damaged.
AT Commands
The AT commands for the Sequans Monarch modem on the GPy are available in a PDF file.
Tutorials
Tutorials on how to the GPy module can be found in the examples section of this
documentation. The following tutorials might be of specific interest for the GPy:
WiFi connection
LTE CAT-M1
NB-IoT
BLE
should be avoided unless WiFi is disabled in your
P12
gpy-wlan-XXXX
.
www.pycom.io
to
3.5v 5.5v
,
. The
412