Table of Contents
Advertisement
READ AND SAVE THIS GUIDE
WARNING!
To reduce the risk of fire, injury to persons or damage when using the appliance, follow the
important safety instructions listed below. Read all the guidance before using the appliance.
Servicing
Do not repair or replace any part of the appliance unless specifically recommended in
z
the user guide. All other servicing should be undertaken by a Fisher & Paykel trained and
supported service technician or qualified person.
Technicians must disconnect the power supply before servicing this appliance.
z
Please make this information available to the person installing the appliance.
z
This appliance must be installed and connected to the mains power supply only by a
z
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty or liability claims.
Gas Requirements
Be sure that the unit being installed is set up for the kind of gas being used. The gas range
z
is shipped from the factory set and adjusted for Natural Gas or LP (propane), depending
on the specific model ordered. Verify that the range is compatible with the gas at the
installation site before proceeding further.
Return range to dealer if the unit is not set for site gas supply.
z
4
SAFETY AND WARNINGS
General
The appliance must not be installed behind a decorative door in order to
z
avoid overheating.
The range must be grounded.
z
Installation must comply with your local building and electricity regulations.
z
Ensure the installer shows the customer where the gas supply shut-off valve is located.
z
A circuit breaker is recommended.
z
If the power supply cable is damaged, it must be replaced by the manufacturer, its service
z
agent or similarly qualified person in order to avoid a hazard.
Do not use adaptors, reducers or branching devices to connect the oven to
z
the mains electricity supply, as they can cause overheating and burning.
Improper installation, adjustment alteration, service or maintenance can cause property
z
damage, injury or death. Read the installation, operating and maintenance instructions
thoroughly before using, installing or servicing this appliance.
A risk of the appliance tipping over exists if the appliance is not installed in accordance
z
with installation instructions.
DO NOT obstruct the flow of combustion or ventilation air to the appliance.
z
Be sure a fresh air supply is available.
Check local building codes for the proper method of range installation. Local codes vary.
z
Installation, electrical connections, and grounding must comply with all applicable codes.
In the absence of local codes, the range should be installed in accordance with the latest
edition of National Fuel Gas Code ANSI Z223.1 and National Electrical Code ANSI / NFPA 70.
In Canada: Installation must be in accordance with the current CAN/CGA B149.1 & 2 Gas
z
Installation codes and/or local codes. Electrical installation must be in accordance with the
current CSA C22.1 Canadian Electrical Codes Part 1 and/or local codes.
Do not lift the range by the door handle. Doing so may damage the product.
z
Before use, ensure all doors are correctly installed.
z
Always keep the appliance area clear and free from combustible materials, gasoline and
z
other flammable vapors and liquids.
Advertisement
Table of Contents
