Figure 12: Side Outlet With Hose - WaterBackpack PAUL Station Manual

®
page 18 PAUL station manual

Figure 12: Side outlet with hose

Remove the black or red cap and install the brass screw with hose connector.
Then mount the hose on the hose connector and fix it with a hose clamp.
®
In standard operation, fix the end of the hose higher than PAUL is, so no water
will flow out of the hose. As the hose is transparent, you can exactly see and
®
observe the water level inside PAUL . This is the "simple and no energy" ver-
sion which in most cases makes the optional LWS unnecessary.
If flushing must be performed, lower the outlet of the hose so water and slurry
®
can flush out of PAUL .
Of course any other solution offering the same functionality is also possible.
PAUL Station Manual 2019-08-02 www.waterbackpack.org 02.08.2019