Table of Contents
Advertisement
page 10
As the connector comes pre-assembled, it has to be divided according to Figure
5.
Then, drill a hole in the RWT using the centre bit ¾" or 1", depending upon your
tank connection diameter.
Figure 4:
RWT connector parts of set1 (top: ¾" version, down: 1" version) pre-
Note:
In raw water, even if filterd at the pump inlet, there will be settleable solids. They will
accumulate at the bottom of the RWT. Thus, it is recommended to place the RWT
connector a little higher above the bottom of the RWT, as is shown qualitative in Fig-
ure 2, depending upon solids content in the raw water etc.
Also, the RWT should have a bottom outlet at the very lowest point of the tank to en-
able flushing out solids from time to time.
Although you are free to chose your most convenient way of mounting, we rec-
ommend the following steps depending upon the diameter of the connector:
PAUL Station Manual 2019-08-02
assembled
www.waterbackpack.org
®
PAUL
station
manual
02.08.2019
Advertisement
Table of Contents
