Maintenance; Daily; Water Level Inside Paul; Sieve Between Rwt And Paul - WaterBackpack PAUL Station Manual

®
PAUL station manual

6 Maintenance

6.1 Daily

6.1.1 Water level inside
The water level inside
siderably low, the
RWT, which might be caused by a dirty sieve, see chapter 6.1.2.
If it is detected, that the water level is low, less than half the height of
the close the valve in the connection between
®
PAUL with some water. Make sure enogh raw water is available.
6.1.2 Sieve between RWT and
The sieve that is mounted between the Raw Water Tank and
checked daily. If it is obstructed, please clean carefully.
If cleaning of the sieve is frequently necessary due to a high Suspended Solids
content of the raw water, maybe a different location of the tank connector in the
RWT might help (maybe it is placed too close to the bottom of the tank where
settleable solids accumulate).
Alternatively, a larger sieve would be necessary. This can be obtained by us
upon request..

6.2 Weekly

6.2.1 Removing slurry from the
All particles that PAUL
be removed on a regular basis.
This can be done by opening the bottom outlet underneath or on the side of
®
PAUL , whatever is easier.
Flush out the slurry, discard it the same way you do with toilet content, and
close the outlet.
PAUL Station Manual 2019-08-02
®
PAUL
®
PAUL should be checked daily. If the water level is con-
®
PAUL is able to filter more water than he gets from the
PAUL
PAUL
®
filters stay in the blue body of
www.waterbackpack.org
®
PAUL and the FWT and fill up
®
®
unit
PAUL
page 23
®
PAUL ,
®
PAUL should be
®
. Thus, they must
02.08.2019