Set 2 To Connect Paul; With The Filtered Water Tank; Overview; How To Install - WaterBackpack PAUL Station Manual

®
page 14 PAUL station manual
heard. Please check from time to time and replace/recharge batteries if needed,
see below.
To check the functionality of the whole LWS system, connect the LWS box to
®
the OPV-S at a low water level inside PAUL – LED and beep should indicate
®
low water condition. After reaching a certain height in PAUL , the alarm will go
off. Of course it can also be switched off by unplugging the sensor cable from
®
the LWS box, but do not forget to reconnect it after PAUL is filled up again.
®
4.2 Set 2 to connect PAUL

with the Filtered Water Tank

4.2.1 Overview

Figure 8 shows how to connect all parts that come with set 2.
Figure 8: All parts that come with set 2 including water meter (left) and float valve
for the FWT (right) and how to connect
®
It is recommended to first put PAUL and the FWT in place before cutting the
®
hose that connects PAUL into the necessary pieces. Also, the requirements
explained hereafter have to be considered.

4.2.2 How to install

®
The standard PAUL unit comes with a white-blue drinking water hose that
ends with a valve.
From this valve, a hose connection to the water meter must be made using the
white-blue hose, see Figure 9 and Figure 10.
PAUL Station Manual 2019-08-02 www.waterbackpack.org 02.08.2019