Table of Contents
Advertisement
PAUL station
manual
If desired (which might be the case in many situations), the wire can easily be extended to
the desired length,. e.g. by placing the LWS box in a nearby flat etc.
The LWS operates with 4 AA batteries. If no warning is issued, there is no current, which
means that the batteries last as long as their official lifetime is. Of course you can also use
AA rechargeable batteries. In order to save battery power due to unwanted conditions dur-
ing transportation, the test knob is covered with a plastic cap. If you need to replace the bat-
teries, open the LWS (4 screws) and remove this plastic, insert new batteries/recharged bat-
teries and close the box again and tighten the 4 screws properly.
Then check functionality of the LWS box itself by pressing the blue knob (see Figure 7, right
hand side) – a LED light should appear and a sound should be heard. Please check from
time to time and replace/recharge batteries if needed, see below.
To check the functionality of the whole LWS system, connect the LWS box to the OPV-S at a
low water level inside
reaching a certain height in
by unplugging the sensor cable from the LWS box, but do not forget to reconnect it after
®
PAUL
is filled up again.
4.2 Set 2 to connect
4.2.1
Overview
Figure 8 shows how to connect all parts that come with set 2.
Figure 8:
All parts that come with set 2 including water meter (left) and single valve for
It is recommended to first put
®
nects
PAUL
into the necessary pieces. Also, the requirements explained hereafter have to
be considered.
4.2.2
How to install
The standard
PAUL
valve.
PAUL Station Manual 2019-05-25
®
PAUL
– LED and beep should indicate low water condition. After
®
PAUL
, the alarm will go off. Of course it can also be switched off
®
PAUL
with the Filtered Water Tank
the FWT (right) and how to connect
®
PAUL
and the FWT in place before cutting the hose that con-
®
unit comes with a white-blue drinking water hose that ends with a
page 12
25.05.2019
Advertisement
Table of Contents
