Dot Notation In Atm Addresses - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands
port number. (This section does not define a PNNI logical port number, nor does it describe the
correspondence between an AXSM port and a PNNI logical port number.) For the correspondence
between a PNNI physical port and the port identifier on an AXSM, see
Table 6-4
PNNI port
Shelf
Slot
Subslot
Port
Subport
As Table 6-4
(or logical port) on an AXSM. An example of a PNNI physical port identifier is 1:2.1:1. This portid
corresponds to an AXSM, with the following particulars:
•
•
•
•

Dot Notation in ATM Addresses

In this chapter, many examples of ATM addresses appear with dots. The dots serve only to aid you when
entering or viewing these fields, which have considerable lengths. The controller strips out the dots.
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Mapping PNNI Port ID to AXSM Elements
AXSM
N/A
Slot
Bay (for upper or lower back card)
Line
Logical interface (or port)
shows, a port to PNNI is a line on the AXSM, and a subport to PNNI is a logical interface
Slot 1
Bay 2
Line 1
Logical interface 1 (or logical port 1)
Table
Cisco MGX 8850 Routing Switch Command Reference
Dot Notation in ATM Addresses
6-4.
6-5