Dsppnport - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

dsppnport

Display PNNI Port—displays PNNI port information.
The dsppnport command shows dynamic, operational data rather than just the configuration data you
would see by executing dspport on a service module.
The total number of connections that the dsppnport shows does not include control VCs. The types of
control VCs are:
•
•
•
To see the connection counts that include control VCs, use the commands that operate on the CLI of the
service modules (dspln, dsppart or dsprscprtn, dspcd, or dspport).
Cards on Which This Command Runs
PXM45
Syntax
dsppnport <portid>
Syntax Description
portid
Related Commands
dspnports, addpnport, delpnport
Attributes
Log: nolog
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Service-specific connection-oriented protocol (SSCOP)
PNNI routing control channel (PNNI-RCC)
Interim local management interface (ILMI) but only if ILMI is enabled
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page
State: active, standby
6-4.
Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dsppnport
6-87