Cnftrapip - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

cnftrapip

Configure Trap IP
The cnftrapip command lets you configure the trap IP for Cisco WAN Manager. You can then use the
command dsptrapip to confirm the value.
Before you use cnftrapip:
1.
2.
For information about installing the SNMP agent for CWM, see Cisco WAN Manager Installation for
Solaris, Release 10.
Cards on Which This Command Runs
PXM45
Syntax
cnftrapip <ip address>
Syntax Description
ip address
Related Commands
dsptrapip, dsptrapmgr, addtrapmgr, deltrapmgr
Attributes
Log: log
Example
Assign IP address 172.27.27.184 to the switch, then use the dsptrapip command to check it.
SanJose.7.PXM.a > cnftrapip 172.27.27.184
SanJose.7.PXM.a > dsptrapip
Trap IP Address :172.27.27.184
SanJose.7.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The SNMP agent must be installed.
The switch's interface must have an IP address. (To assign an IP address to a switch's interface, use
ipifconfig.)
The switch's ethernet IP address on which the traps are configured.
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
cnftrapip
6-55