Advertisement
Inserting the Cards
To insert a Cisco IGX module:
Step 1
Note
Step 2
Step 3
Step 4
Figure 3-6
Step 5
Caution
erroneous system error messages, and indicate card failure. However, do not use the ejector levers to lift or
support the weight of the cards.
Step 6
Attach an ESD-preventive wrist strap to handle the cards.
The IGX 8410 cabinet has an attached wrist strap both at the front and back.
Using the 5/32-inch Allen wrench, open the Cisco IGX 8400 Series switch door.
Be sure that you are inserting the module into the correct slot.
Grasp the card front panel with one hand and place your other hand under the card to
balance the weight of the card as you push it vertically into the slot. (See Figure 3-6.)
Inserting Modules
HCPU
SYSTEM
STATUS
0
1
LL
2
RL
DTR
3
TXD
DCD
RXD
4
5
6
7
8
9
10
11
ALM
LDM
FAIL
ACTIVE
NPM
Push down on the ejector levers to properly seat the card.
Always use the ejector levers when disengaging or seating the modules. Failure to do so can cause
Using the number 1 Phillips screwdriver, tighten the panel fasteners at the top and bottom
of the card front panel.
MINOR
MINOR
MINOR
MAJOR
MAJOR
MAJOR
LL
RL
DTR
TXD
DCD
RXD
FAIL
FAIL
FAIL
ACTIVE
ACTIVE
ACTIVE
STANDBY
UXM
HDM
UFM
NTM
Inserting the Cards
Card Installation and Node Startup 3-7
Advertisement
