Operation; Startup; Switching On / Off; Drilling - Mafell DD40P Operating/Safety Instructions Manual

5

Operation

5.1 Startup

These operating instructions must be brought to the attention of all persons entrusted with the operation of the
machine, with particular emphasis on the chapter "Safety instructions".

5.2 Switching on / off

Use the following procedure to switch on the
machine:
1. Press the power switch (2) forward until it
engages.
The machine is switched on.
✓
Use the following procedure to switch off the
machine:
1. Press on the rear end of the power switch (2).
The power switch jumps to the OFF
➢
position.
The machine is switched off.
✓

5.3 Drilling

The base plate is equipped with two resilient stop
pins (15). They are used to drill the boreholes at a
fixed distance of 15.5 mm [0.61 in] from the outer
edge of the workpiece.
There are contact surfaces (16) on the sides of the
base plate. They are to drill the boreholes at a fixed
distance of 49 mm [1.93 in] from the outer edge of the
workpiece.
The machine can be mounted on the left and on the
right side.
16
Fig. 10: Switching the machine ON/OFF
Fig. 11: Base plate with stop pins and contact surfaces
DD40P
01/2022