Xantrex PV-100208 Operation And Maintenance Manual page 16

100 kw grid-tied photovoltaic inverter

Table of Contents

SECTION 3

INSTALLATION AND INITIAL TURN-ON

Power Tracker Fine Tuning:

• All PV-100208 operating parameters have been set at the factory, based upon prior experience with

PV arrays.

• It is recommended that the PV-100208 be watched during Wake-Up and Sleep Test. If the PV-

100208 cycles between operating and sleeping at either of these times, the condition setpoints are

not set properly (refer to section 4 for detailed description of PV-100208 state transitions). The

PV100208 should not cycle if the setpoints are set properly.

Some field adjustable parameters are password protected and may only be changed

by trained service technicians. In particular are parameters relating to utility

protection setpoints. These have been set in the factory to the limits mandated by

UL1741. Any changes to these setpoints should be agreed upon by the local utility

and the equipment owner.

Visually inspect the exterior surfaces for any damage (nicks, chips, exposed base

metal and scratches) that may have occurred during shipment or installation.

Touch up or recoat using White NISSEN Feltip Paint Marker, or equivalent to

prevent rust or corrosion.

DOCUMENT: 151700

NOTE

PV-100208 Photovoltaic Inverter

Operation and Maintenance Manual

3-8

Table of Contents