Table of Contents
Advertisement
PROBLEM
Noises
Vibration
Creasing
TROUBLESHOOTING
POSSIBLE CAUSES
Dryer is overloaded.
Dryer has a fault.
Beeps signalling the end
of a drying cycle.
Dryer has not been levelled
properly.
Dryer makes unfamiliar noises.
Dryer is not installed on
a stable surface.
Dryer is not level.
Dryer is overloaded.
Cycle selection not
appropriate for the load.
Dryer is overloaded.
'Dryness Level' selected
too high for load type.
'Wrinkle Free' option not
selected.
WHAT TO DO
Remove some items from the dryer.
Continuous beeping or a musical
series of beeps with a message
displayed on the display.
Refer to 'Fault codes'.
End of cycle beeps can be turned off
refer to 'Customising dryer settings'.
Refer to 'Levelling the machine' in the
installation section of this guide.
At the start of the cycle the dryer may
make some unfamiliar noises when the
compressor turns on. This is normal.
Ensure the dryer is installed on a flat,
stable surface. Refer to 'Levelling the
machine' in the installation section of
this guide.
Ensure the dryer is correctly levelled.
Refer to 'Levelling the machine' in the
installation section of this guide.
Remove some items from the dryer.
Select the 'Easy Iron' cycle to
minimise creasing.
Remove some items from the dryer.
Try selecting a lower 'Dryness Level'.
Select the 'Wrinkle Free' option to
rotate the load at the end of the
drying cycle. Refer to 'Wrinkle Free'
section of this guide for details.
31
Advertisement
Table of Contents
