Table of Contents
Advertisement
PROBLEM
Dryer is taking
too long
/results were
not satisfactory
Dryer is not
draining
TROUBLESHOOTING
POSSIBLE CAUSES
Drying cycle selected not
appropriate for the load.
Dryness level selected not
appropriate for the load.
Dryer overloaded for
the cycle.
Lint and/or condenser filter
is blocked.
Water tank is full.
Environmental conditions may
be affecting dryer operation.
Load overly wet at the
start of cycle.
Load was damp dry at the
start of cycle.
Dryer not draining water
out properly.
Items got tangled.
Drain hose not connected
to the water tank.
Water tank not in place
correctly.
Drain hose or drain blocked
or damaged.
WHAT TO DO
Select an appropriate cycle for the
load. Refer to 'Drying cycles'.
Select a higher dryness level.
Refer to 'Dryness Level'.
Some cycles have a lower max load
size. Refer to 'Drying cycles'.
Try dividing the load in half and
dry half at a time.
Clean the lint/condenser filter.
Refer to 'Emptying the water
collection tank'.
In particularly hot or cold conditions
the dryer will take longer to dry a load
and be less efficient.
Ensure the dryer is installed in a
well-ventilated, dust-free environment.
Do not operate this dryer behind
closed doors (ie inside a cupboard).
Remove more water from the
load before placing it in the dryer,
eg select a faster spin speed on your
washer, if appropriate for your load.
If the load had been partially air dried,
eg has been washed and placed on
the line, use a 'Time Dry' cycle and
monitor the dryness of your clothes.
Check the drain hose (if connected)
for blockages or damage.
You may need to call for service
refer to 'Customer care' section.
Try separating items and drying
similar items together. Refer to
'Loading' for further tips.
Ensure the drain hose is connected
correctly. Refer to 'Draining' in the
installation section of this guide.
Ensure water tank is properly in place.
Check drain hose (if connected)
and drain for blockages or damage.
29
Advertisement
Table of Contents
