Cleaning And Maintenance; Cleaning - Parkside PDOS 200 C2 Translation Of The Original Instructions

GB IE NI
The grinding disc nuts (
have different threads (left-hand
and right-hand threads). To avoid
damaging the grinding disc spindle
thread (
two grinding disc nuts (
1. Undo the fi xing screws (
and remove the left-hand and
right-hand grinding disc cover
( 8).
2. Unscrew the grinding disc nuts
(10a) by counter-holding the nut
on the opposite grinding disc
with a spanner (size 19 mm).
Unscrewing the left-hand nut (left-
hand thread): turn clockwise.
Unscrewing the right-hand nut
(right-hand thread): turn anti-
clockwise.
3. Remove the clamping fl ange
(10b) and the grinding disc (10).
4. Set up the new grinding disc
(10) with the intermediate shims
(10c) made of cardboard and the
clamping fl ange (10b) and manu-
ally screw the grinding disc nut
(10a) on.
Screwing the left-hand nut (left-
hand thread) on: turn anticlock-
wise.
Screwing the right-hand nut
(right-hand thread) on: turn clock-
wise.
5. Screw the left hand and right
hand grinding disc covers (8) on.
6. Adjust the spark protection (
and the workpiece support
11): The distance to the
(
grinding disc (10) must not ex-
ceed 2 mm (see "Assembly").
14
CY
10a)
15), never mix up the
10a).
The grinding disc nut must not be
screwed too tightly in order to
avoid a breaking of the grinding
disc and nut.
7. Test run:
7)
Cleaning and
maintenance
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original components.
Allow the equipment to cool
before carrying out any main-
tenance and cleaning work.
There is a risk of burns.

Cleaning

Do not use cleaning agents or sol-
vents. Chemical substances may at-
tack plastic parts of the equipment.
1) Never clean the equipment
under running water. WARN-
ING! Electric shock hazard.
• Clean the equipment thoroughly after
each use.
• Clean the surface of the equipment
with a brush or cloth.
Before starting work and after
each change of grinding disc,
carry out a test run of at least
60 seconds with no load. Switch
off the equipment immediately if
the disc runs lumpy, substantial
vibrations occur, or abnormal
noises are generated.