HYDROCLIMA 2 - User Manual Contents Preface Safety and warranty Important information Intended use of the product Lithium batteries safety guidelines Precautions for lithium batteries General information Packaging content Installation and connection Installation Exterior temperature sensor installation (EXT version) Display...
This User’s manual comprises rules, information and advices regarding proper use of the heat cost allocator HC2 manufactured by B METERS Company. Please, read this manual before using the product. It shall enable a proper and safe operation of the product.
HYDROCLIMA 2 - User Manual General information Hydroclima 2 is a two sensor, electric, second generation heat cost allocator. It is intended to measure directly consumed thermal energy emitted by a radiator. The heat cost allocator provides non-dimensional units of the thermal energy consumption depending on a temperature of a radiator and a temperature of a room.
HYDROCLIMA 2 - User Manual Installation and connection Installation An Heat cost allocator can be install at radiator in two steps. Firstly, an aluminum heat sink is fixed to a radiator. Depending on type of a radiator and dedicated installation technology, the following methods are applied: fixing elements, welding or gluing.
HYDROCLIMA 2 - User Manual Exterior temperature sensor installation (EXT version) The external temperature sensor (separate component) has to be connected before heat cost allocator is installed. This operation consists of three steps: 1. First of all, upper edge of the temperature sensor has to be placed in the socket to tilt plastic hook 2.
HYDROCLIMA 2 - User Manual Display To present the data, a digital display with icons is available. A full lines test of the display is presented below: The heat cost allocator shows data in two modes, a basic mode and an extended one: →...
Page 8
HYDROCLIMA 2 - User Manual In case of recording of the following events, additional results are displayed, whether or not the display has been initiated to present the data: → A heat cost allocator with data presentation switched off (data presentation in a loop, with messages displayed...
Page 9
HYDROCLIMA 2 - User Manual Examples of indications: Display test - all segments on Closing date of a clearing period Display test - all segments off Control code Present consumption [C] Serial number last 6 digits Collective information on a group...
HYDROCLIMA 2 - User Manual Button The timing of button pressure corresponds to the following events: → Non-configured heat cost allocator (factory settings); Pressing the button for the first time prepares the device to receive the configuration data. After a successful configuration the “CONF” information appears in the display.
HYDROCLIMA 2 - User Manual Configuration Programming and configuration of the device is carried out by radio, using an RFM-RX2 and BMetering software. To trigger the configuration procedure, the BMetering software must be properly configured: → For the factory state of the allocator, press the button for < 1s, →...