Page 1
8. REED SENSOR INSTALLATION ONTANGENTIAL TAN-X5 9. CHECKS TO BE CARRIED OUT IF THE PULSE SENSOR DOES NOT WORK REPLACEMENT OF DEFECTIVE PARTS B METERS srl Cod. Fisc. e P. IVA n°: IT01750340307 Tel. +39.0432.931415 - 931418 Cap. Soc. € 500.000,00 i.v.
Our pulse emitters can be equipped (as an option) with a further with Reed contact, which produces an alarm signal when the external magnet approaches the water meter. NORMALLY OPEN NORMALLY CLOSED B METERS srl Cod. Fisc. e P. IVA n°: IT01750340307 Tel. +39.0432.931415 - 931418 Cap. Soc. € 500.000,00 i.v.
Operating temperature ( ° C ) Max frequency ( Hz ) max IP protection Cable lenght N.B. REED contact requires power to operate B METERS srl Cod. Fisc. e P. IVA n°: IT01750340307 Tel. +39.0432.931415 - 931418 Cap. Soc. € 500.000,00 i.v. Via Friuli n°3 Fax +39.0432.992661...
Page 4
GSD8 1 litre GSD5 1 litre 10 litres 100 litres 1000 litres B METERS srl Cod. Fisc. e P. IVA n°: IT01750340307 Tel. +39.0432.931415 - 931418 Cap. Soc. € 500.000,00 i.v. Via Friuli n°3 Fax +39.0432.992661 33050 GONARS (UD) Reg. Impr. di UD n° Iscr. 01750340307 www.bmeters.com...
Page 5
1) install the meter 2) insert the impulse device 3) Insert the wire trough the holes and close the seal B METERS srl Cod. Fisc. e P. IVA n°: IT01750340307 Tel. +39.0432.931415 - 931418 Cap. Soc. € 500.000,00 i.v. Via Friuli n°3 Fax +39.0432.992661...
Page 6
N.B. The wire color can vary without notice; the only wire that remains unchanged is the white protection one. B METERS srl Cod. Fisc. e P. IVA n°: IT01750340307 Tel. +39.0432.931415 - 931418 Cap. Soc. € 500.000,00 i.v.
Page 7
REED sensor on your own you must remove the seal and by doing this you lose the warranty. If you want to keep the warranty, please send the meter back to B Meters that will take care of the installation and proper sealing.
Page 8
If you want to keep the warranty, please send the meter back to B Meters that will take care of the installation and proper sealing.
4) Remove the sensor and pass a magnet at its bottom using a tester to verify the functioning. 5) Try tapping the sensor and move the wires then recheck with the tester. If these tests have failed, then return the sensor to B METERS that will replace it. 9.2 Water meter Those listed below are the checks to be carried out if the sensor is working, but during water meter operation does not counts.
Page 10
N.B. If the sensor has been fed at a different voltage than the one specified and consequently burned, BMETERS will not replace it under warranty. B METERS srl Cod. Fisc. e P. IVA n°: IT01750340307 Tel. +39.0432.931415 - 931418 Cap.