B meters HYDRODIGIT-S1 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. B meters Manuals
  4. Measuring Instruments
  5. HYDRODIGIT-S1
  6. Operating instructions manual

B meters HYDRODIGIT-S1 Operating Instructions Manual

Hide thumbs Also See for HYDRODIGIT-S1:
Table of Contents

Advertisement

Quick Links

EN
HYDRODIGIT-S1
Digital single jet smart meter
OPERATING INSTRUCTIONS

Advertisement

Table of Contents
loading

Related Manuals for B meters HYDRODIGIT-S1

Summary of Contents for B meters HYDRODIGIT-S1

  • Page 1 HYDRODIGIT-S1 Digital single jet smart meter OPERATING INSTRUCTIONS...

  • Page 2: Table Of Contents

    INSTALLATION REQUIREMENTS OPERATION DISPLAY DELIVERY STATUS OPERATING MODE - RADIO ACTIVATION RADIO PARAMETERS DEVICE DISPLAY LOOP ERROR MESSAGE BATTERY AND REPLACEMENT PROCEDURES INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT TRANSLATION TECHNICAL DATA DECLARATION OF CONFORMITY MANUFACTURER ADDRESS HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 3: Content

    CONTENT DESIGN According ISO4064 Size (1/2”) (1/2”) (3/4”) D Threading 3/4” 3/4” 1” HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 4: Device Dial

    MAP16 U0-D0 ∆P 63 IP68 unit number 2031 Manufacturer Measuring class/Permitted position of installation RxxH: Model horizontal installation RxxV: vertical installation RxxVH: vertical and IR interface horizontal installation End-life Maximum Manufacturer address expiration year admissible pressure HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 5: Functionality

    • Storage: from -20°C to +70°C • Operating: from +1°C to +55°C • The storage period must not exceed 1 year • The water meters are precision devices and must be protected from shocks and vibration HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 6: Safety Instructions

    For more information visit www.bmeters.com. Dispose of replaced instruments and defective components in accordance with the environmental regulations in force. HYDRODIGIT-S1 User Manual v1.4.5...
  • Page 7 Install the meter in order to be protected from all impurities and contamination. Remove the old gaskets and clean the sealing surfaces. Grease sealing surfaces (use acid-free, potable water approved grease). The device may only be installed in frost-free areas. HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 8: Installation Requirements

    All the versions of the water meter can be installed both horizontally and vertically. For a better performance it is preferable, however, the horizontal installation, with the turbine axis perpendicular to the ground and the reading mechanism facing upwards. HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 9: Operation

    • Transmission frequency: every 200 seconds (current values). • Transmission intervals: every day, from 0 to 24 h. • Encryption: disabled (default). • No historical data. • Transmitted data: volume, actual date and time, reverse flow, alarms. HYDRODIGIT-S1 User Manual v1.4.5...
  • Page 10 LoRaWAN transmission standard. During this process, the radio icon on the display will blink every second. If the procedure is successful, the icon will remain active and stable, otherwise it will turn off. HYDRODIGIT-S1 User Manual v1.4.5...
  • Page 11 It is possible to change the configuration parameters into Walk-By mode with an USB to IR interface (B METERS mod. UC-Cable) and the B Metering software: LoRaWAN: • Transmission frequency: every 6 hours (current data) •...

  • Page 12: Device Display Loop

    10 seconds Flow: present Radio: activated Firmware version Fu_01_01 (In the “COMBO” version, “Combo 2 seconds 002” will be displayed) 2 seconds Display test “ALL ON” 2 seconds Display test “ALL OFF” 2 seconds Error message HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 13: Error Message

    ERROR MESSAGE If an error occurs, an error message is displayed. The error message will be integrated into the device display loop for 2 seconds. Error Type Descrizione Activation Troubleshooting Reset Radio telegram I_ _ _ _ Err Backflow Reverse flow detected, a flow in The error activates after continuous Check water network and the Reset the alarm via LoRa...

  • Page 14: Battery And Replacement Procedures

    Do not expose the battery to an extremely low pressure environment which could cause an explosion or a leak of gases or flammable liquids; Always dispose of batteries in compliance with current regulations; Always use original spare parts authorized by the manufacturer. HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 15: Information For Correct Disposal Of The Product

    For deliveries to countries in the European Economic Area, the operating instructions are to be translated into the appropriate language of user country. Should there be any inconsistencies in the translated text, the original operating instructions (Italian) are to be consulted or the manufacturer should be contacted. HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 16: Technical Data

    …) where propagation of the radio signal can therefore vary. *** The battery life strongly depends on the working time window, set during the configuration process, and on the environmental conditions. Estimation of the battery life is given by the configuration software. HYDRODIGIT-S1 User Manual v1.4.5...

  • Page 17: Declaration Of Conformity

    1. Product type/model: Water Meter – HYDRODIGIT 2. Name and address of the manufacturer: B METERS SRL Via del Friuli, 3 – 33050 GONARS (UDINE) ITALY 3. This declaration of conformity is issued under the sole responsibility of the manufacturer.

  • Page 18: Manufacturer Address

    MANUFACTURER ADDRESS B METERS srl Via Friuli, 3 • Gonars 33050 (UD) • ITALY Tel: +39 0432 931415 Tel: +39 0432 1690412 Fax: +39 0432 992661 E-mail (sales/info): info@bmeters.com E-mail (support): ticket@bmeters.com Web: www.bmeters.com HYDRODIGIT-S1 User Manual v1.4.5...

Table of Contents