Table of Contents
Advertisement
NOTE:
We have used Ubuntu version 20.04 LTS.
Target setup
The Dell EMC Edge Gateway 3200 with the Elkhart Lake Platform and with Windows 10 Enterprise LTSC 2019 installed.
Perform changes in the BIOS
Steps
1. At the BIOS menu, select Chipset > PCH-IO Configuration > PSE Configuration > OOB [Enabled].
2. Set this OOB to be Enabled. OOB provisioning will fail in OOB service provisioning if this is not set to Enabled.
3. At the BIOS menu, select Chipset > PCH-IO Configuration > PSE Configuration > GBE0 [PSE owned with pin
muxed].
Figure 48. Configure OOB enabled
4. Press the Esc button to return to the main menu. When prompted with Save Changes and exit?, press Y to save the
settings.
5. Perform a hard reset by turning the power off and on again. This is necessary when changing a PSE-related setting.
6. Connect an Ethernet cable to PSE GbE0.
Results
You have now set up hardware network connectivity on the target board, which is now ready to connect with the Cloud Service
Provider (CSP), as detailed in the following sections.
Cloud setup and configuration
About this task
The cloud adapter module maps specific cloud functions based on the cloud service provider and implements specific cloud
customizations such as Message Queuing Telemetry Transport (MQTT) topics and message formats.
48
Setting Up the Windows 10 Operating System
Advertisement
Table of Contents
