LYSON C-01 Series Instruction Manual page 3

MACHINERY FOR HONEY CREAMING
WITH AUTOMATIC CONTROL
OF THE C – 01 SERIES
POWER SUPPLY - 400V
Before using the device, be sure to read the instructions for
use and follow the instructions contained therein. The
manufacturer is not liable for damages caused by the use of
the device contrary to its intended purpose or inappropriate
handling.
1. General safety rules of utilisation of machine for
honey creaming
1.1. ELECTRICAL SAFETY
a) Device (machine) must be connected to a socket with a
protective earthing connection with the voltage specified
on the nameplate of the product.
b)
Electrical installation powering the device must be
equipped with RCD (residual current device) with a rated
tripping current In no higher than 30mA. Check the function
of the RCBO (residual current operated circuit-breaker with
integral overcurrent protection)
periodically.
c)
Periodically inspect the condition of the power cord. If the
non-detachable power cord is damaged and it needs to be
replaced. Then this operation should be carried out as
guarantor or by a specialised repair facility or a qualified
person in order to avoid the risk. Do not use the device
when the power cord is damaged.
d)
In the case of damage to the device, in order to avoid the
hazard, repair may be carried out only by a qualified
repair facility or the qualified person.
e)
It is forbidden to pull the power cord.
The power cord must be kept away from heat sources, sharp
edges and take care of its satisfactory condition.
1.2. OPERATIONAL SAFETY
a)
This equipment is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities , or lack of experience and knowledge
concerning the equipment unless this is done under the
supervision or in accordance with the instructions for use
of the equipment, handed over by persons responsible for
their safety. You should pay attention to the children, to
ensure they do not play with the appliance.
b) The ground on which the appliance stands should be dry!
c)
Before working with the device, make sure that the
"emergency stop" button is not pressed (you must turn it
so in order to button jumped out – it clicks).
d)
Pressing the "emergency stop" button enables immediate
stopping the machine for honey creaming operation/ work.
e) Cover of the machine for honey creaming when working
agitator should be closed!
f) Do not rearrange of the machine for honey creaming
during operation.
g) You must protect the engine and control against moisture;
(also during storage)
h) Do not use the device in the vicinity of flammable
materials.
i) Do not carry out any maintenance work when the
appliance is operating.
j) All guards when the appliance is operating must be
permanently attached to the device.
k)
In the event of any hazard, you should immediately use
the safety switch. Restart the machine for honey creaming
may occur after the elimination of the hazard.
l) These devices are not designed for use outdoors, may be
operated only within the premises.
Ban on repairing the device which is in motion
Ban on removing guards when operating the device
2.CONTROLLER OF MACHINE FOR HONEY
CREAMING OF THE C – 01 SERIES –
POWER SUPPLY 400V
Fig 1. Creaming machine controller handling panel
Once power supply is connected, the controller performs self-
diagnostics to acknowledge the correct device operation. Error
detection is signalled by the relevant code being displayed on
the LCD screen.
If errors have not been detected, the screen display will look like
in Fig. 2.