Light Tower Components - MULTIQUIP LT6KV Operation Manual

Light tower/generator
Table of Contents

Advertisement

Figure 3, 4, and 5 show the location of the controls and
components for the LT6KV light tower. The function of each
component is described below:
1. Ball Hitch Coupler — Attach the trailer's 2-inch coupler
to the towing vehicle. Use only the specified ball diameter
as indicated on your coupler. Use of any other ball
diameter will create an extremely dangerous condition
which can result in separation of the coupler and ball
or ball failure.
2. Tongue Jackstand — Use this jackstand to support the
tongue when attaching the light tower to a towing vehicle.
3. Side Marker Lights — There are four side marker lights
located on light tower. The front circular lights (tongue
side) are amber. The rear rectangular reflectors are red.
4. Manual Holder — Contains information regarding the
light tower.
5. Panel Light — When the cabinet door is raised, the
light will automatically turn on. When the cabinet door
is closed, the light will turn off.
6. Control Panel — Contains the auxiliary output
receptacles, engine hour meter, excitation capacitor
and circuit breakers.
LT6KV LIGHT TOWER • OPERATION MANUAL — REV. 2 (07/08/16) — PAGE 21
8
4
3
1
2
11
Figure 3. Major Components 1 (Control Panel Side)

LIGHT TOWER COMPONENTS

6
5
MAIN
GFCI
NOTICE/AVIS
NEUTRAL BONDED TO FRAME
LIEN NEUTRE AU CHÂSSIS
120/240 VAC
MAX. 15A
120 VAC
MAX. 25A
P/N 44199
P/N 44214
P/N 44215
10
7
11
12
7. Winch Control Panel — Contains the mast control
switch necessary for raising and lowering the light tower
mast.
8. T-Bar — Allows the lights to be mounted vertically,
horizontally, and various tilt angles as a whole system
or independently.
9. Engine — 3-cylinder, water cooled, direct injection,
12 HP diesel engine.
10. Engine Status Module — Displays engine status via
LEDs, water temperature, air filter, fuel, alternator, oil
pressure, glow plugs. Insert ignition key, turn clockwise
to start engine.
11. Tie-Down Points — Used to tie down light tower with
straps or chains to allow even application of force to the
front and rear of the equipment during transport.
12. Chock Blocks — Place blocks (not included as part
of the light tower package) under each trailer wheel to
prevent rolling.
9
3

Advertisement

Table of Contents
loading

Table of Contents