MULTIQUIP LT6KV Operation Manual page 22

13. Lights — Four 1,000-watt metal-halide bulbs with a
110,000 lumens capacity each. Four light coverage is
typically between 5 to 7 acres.
14. Mast Rotation Handles — Hold these handles and
turn the light tower mast either left or right depending
on the desired light position/direction.
15. Forklift Pockets — The light tower can be lifted by
inserting the forks of a forklift as far possible into the
lifting bale pockets.
16. Electric Winch Hoist — Lifting device capable of raising
or lowering 800 lbs (363 kgf). The hoist consists of a
motor, rotating drum with wire rope, reduction gears, a
base, and an electrical control system.
17. Mast Rotation Locking Knob — Unscrew this knob to
release mast for rotation. Tighten this knob to lock mast
after it is set to the desired position.
18. Fuel Tank/Cap — Remove cap to add Low Sulfur No. 2
diesel fuel. Fuel tank capacity is 34 gallons (103.6 liters).
19. Battery — The 12-volt DC batter y (CA:550/
CCA:430) is shipped wet and is ready for use.
Battery is shown here for clarity.
PAGE 22 — LT6KV LIGHT TOWER • OPERATION MANUAL — REV. #2 (07/08/16)
23 15
3
Figure 4. Major Components 2 (Fuel Fill Side)
LIGHT TOWER COMPONENTS
13
14
15
16
17
18
3
19
22 21
20. Safety Chain — Always attach safety chains to the
towing vehicle. NEVER tow the light tower with the safety
chain unattached. Make sure safety chains are crossed
when towing.
21. Tongue Mast Foot Step — Welded to the tow tongue.
Use for safety before stepping onto the vertical mast
deck.
22. Vertical Mast Deck — Supports the vertical light tower
mast and provides a safe and level footing when mast
rotation is required.
23. Lifting Bale — Attach a suitable lifting device to lifting
bale whenever lifting of the light tower is required.
Includes two forklift pockets.
20