Wake Up On Lan - CHAINTECH 7VIA1 Manual

166MHz CPU Clock (JP31)
Pin Definition
1~2 JP3 Enable
2~3 166MHz
CD-ROM Audio-in Connector (CN2/CN2A)
G N D
L R
1
Auxiliary Audio-in Connector (CN3)
AC3 Surround/Center + Bass Connector (CN4B)
Optional S/PDIF-in/out Connector (CN4C)
WOL (Wake-on-LAN) Connector (CN5)
Blue LED Connector(CN17)
This jumper allows user to configure the CPU clock speed at
166MHz. by setting the jumper cup to pin 2-3. The External Clock
Frequency (JP3) will automatically disable. To enable JP3 function,
set the jumper cup to pin 1-2.
Use the audio cable enclosed with your CD-ROM disk drive to
connect the CD-ROM to your mainboard. This will enable your
CD-ROM's audio function.
This connector is for use with a secondary CD-ROM, DVD-ROM
or CDR/CDRW disk drive.
This connector is for Surround and Center+Bass speaker output
ext. Plug in the optional AC3 Surround/Center+Bass jack extension
into this connector. The black colored jack is for surround
speaker output and the orange colored jack is for center+bass
speaker output.
The S/PDIF-in/out connector supports the digital audio. This
connector must be connected to the cable from an external device
(i.e.2-channel decoded AC-3 from DVD decoders).
Enable the Wake Up On LAN selection in BIOS's Power
Management Menu to use this function. This header is used
to connect an add-in NIC (Network Interface Card) which gives
WOL capability to the mainboard.
This feature work entirely the same as the power indicator LED,
both shows the system's power status. The only difference is that
this one is blue while the other is red LED.
Hardware Setup
9