Table of Contents
Advertisement
Handling static-sensitive devices
Attention:
To avoid damage, keep static-sensitive devices in their static-protective packages
until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the switch without
v Take additional care when you handle devices during cold weather. Heating
Static electricity can damage the switch and other electronic devices.
you.
electrostatic-discharge wrist strap, if one is available.
metal part of any unpainted metal surface on a grounded rack component in the
rack in which you are installing the device, for at least 2 seconds. This drains
static electricity from the package and from your body.
setting it down. If it is necessary to set down the device, put it back into its
static-protective package. Do not place the device on a switch cover or on a
metal surface.
reduces indoor humidity and increases static electricity.
Chapter 2. Installing the RackSwitch G8264CS
15
Advertisement
Table of Contents
