Contact Equipment For Mig/Mag Welding - ESAB A2 TF Instruction Manual

GB
4.5

Contact equipment for MIG/MAG welding

4.5.1 For single wire 1.6 - - 2.5 mm (D35)
Use automatic welding machine A2 TG (MIG/MAG)
where the following are included:
Wire feed unit (1),
S
Connector D35 (2)
S
Contact tip (3) (M10 thread).
S
Tighten the contact tip (3) with a key in order to
ensure that a good contact is achieved.
4.5.2 For single wire < 1.6 mm (D35)
Use automatic welding machine A2 TG (MIG/MAG)
where the following are included:
Wire feed unit (1),
S
Connector D35 (2)
S
Contact tip (3) (M12 thread).
S
Guide tubes (4).
S
Tighten the contact tip (3) with a key in order to
ensure that a good contact is achieved.
Use the following accessories:
Fine--wire straightener (5) to be fitted on top of
S
the clamp of the wire feed unit (1).
Guide spiral to be inserted into the guide tube (4).
S
fhb5o1ea
- - 90 - -