Table of Contents
Advertisement
Available languages
Available languages
Britax Child Safety, Inc.
Comfort Pillow
The comfort pillow is
designed to provide better fit
and comfort for infants using
this child seat.
NOTE: Remove the
comfort pillow after the
child can sit comfortably
in the child seat without
additional support.
Seat Position
This child seat has seven (7)
recline positions. To adjust
the recline position:
1. Pull the recline handle
then rotate the child seat
shell until the recline
indicator ball is in the
correct position for the
specific installation
(See Using the Recline
Indicator below).
2. Release the recline handle, then verify the child seat has
locked into position.
NOTE: Set the seat position BEFORE installing.
Using the Recline Indicator
• Rear Facing Installations -
It is important that the child
seat be properly reclined.
Use the recline indicator
on the child seat to help
achieve an acceptable
recline angle for:
‐ infants and children with
no head and neck control
- recline indicator ball in the light blue section.
‐ older children with proper head and neck control -
recline indicator ball in light blue or dark blue.
NOTE: If necessary, the proper recline angle can be
achieved by placing a rolled towel or pool noodle in
the vehicle seat bight.
• Forward Facing Installations - Use the recline indicator on
the child seat to help achieve an acceptable recline angle,
with the recline indicator ball in the green section.
WARNING!
This seat must not be used in a position other than
upright for forward-facing lap-shoulder belt and lap belt
installations.
28
Table of Contents
Toddler
Infant
ADVOCATE/BOULEVARD CLICKTIGHT User Guide
Overhang
It is important that the
base of the child seat
rests completely flat on
the vehicle seat with no
side overhang. As seen
in the illustration, it is
permissible to allow up to
7.5 cm (3 in.) of the base
to hang over the front
edge of the vehicle seat.
If the vehicle seat does
not allow enough of the
child seat base to make contact, adjust the recline angle to
a more upright position. Not doing so could cause the child
seat to not perform as intended.
IMPORTANT:
Car seat base MUST be flat on vehicle seat and
MUST be parallel to vehicle seat.
WARNING!
In some cases, the vehicle head
restraint can prevent the child seat
head restraint from being raised
high enough to properly adjust the
harness for the fit of your child when
using a forward-facing reclined
position. DO NOT force the child
seat head restraint past the vehicle
head restraint. Doing so could cause the child seat not to
perform as intended. If the location of the vehicle head
restraint interferes with the child seat head restraint,
raise, or remove the vehicle head restraint. If the vehicle
head restraint cannot be removed, move the child seat to
the upright position or try a different seating location.
Uninstalling the Seat
1. Unbuckle the vehicle seat
belt.
NOTE: For car seats
installed with lower
connectors, see pages
31-32.
2. Open the CLICKTIGHT.
a. Press the dimple on
the CLICKTIGHT dial.
b. Rotate dial clockwise
until CLICKTIGHT
releases and lift to
open.
Table of Contents
7.5 cm
Acceptable
Acceptable
Forward-Facing
Rear-Facing
2a
7.5 cm
2b
29
Advertisement
Table of Contents
