Table of Contents
Advertisement
Available languages
Available languages
Britax Child Safety, Inc.
LUAS Installation
IMPORTANT:
Do not install forward facing with lower anchors
for a child weighing more than:
‐ ADVOCATE ONLY: 15.8 kg (35 lbs)
‐ BOULEVARD ONLY: 18 kg (40 lbs)
1. Remove the lower
connectors from the
storage compartment at
the rear of the seat and
pull the strap to full length
toward the child's left
side.
2. Remove the tether
from the tether storage
compartment and retainer
tabs and place it up and
over the child seat back.
3. Place forward-facing on
the vehicle seat.
NOTE: Ensure that the
base of the child seat is
flat on the vehicle seat
and no more than 3 in.
(7.5 cm) of the base
hangs over the edge
of the vehicle seat (see
page 29).
4. Open the CLICKTIGHT.
a. Press the dimple on
the CLICKTIGHT dial.
b. Rotate dial clockwise
until CLICKTIGHT
releases and lift to
open.
5. Slide the lower connector
strap into the forward-
facing belt slots and
firmly press the lower
connectors over their
adjacent lower anchors.
NOTE: Verify that the
connectors are secure
and the strap is not
twisted.
6. Pull the end of the lower
connector strap to
remove slack.
18
Table of Contents
7.5 cm
4a
4b
ADVOCATE/BOULEVARD CLICKTIGHT User Guide
7. Hold harness straps up
and away from seat while
closing the CLICKTIGHT.
NOTE: A click
helps confirms the
CLICKTIGHT is secure.
8. Attach the tether to a
designated anchor (see
vehicle owner's manual)
and remove slack (see
page 33).
Forward-Facing Installation with Lower Anchors
9 Logo on the CLICKTIGHT dial has returned to a horizontal
position.
9 All connections are secure and straps are not twisted.
9 Child seat base is be flat on vehicle seat and is parallel to
vehicle seat.
9 Recline indicator ball is within the allowable blue section for
the size of the child and that no more than 7.5 cm (3 in.) of
the base hangs over the edge of the vehicle seat (see page
28).
9 Child seat cannot be moved front to back or side to side
more than 2.5 cm (1 in.) at the belt path. If the child seat
is not secure, repeat installation or use a different seating
location.
9 Excess top tether webbing is contained within your vehicle
and secured.
9 The anti-rebound bar is removed.
Table of Contents
19
Advertisement
Table of Contents
