Advertisement
Step 12
You will need
8 x Cam Bolts
6 x Screws
(H1)
12mm (H6)
Phillips Head
4 x Slides
Screwdriver
(H7)
8 x Dowels
Mallet
(H3)
Note the position
of the rubber stopper
H7-1
H3
H3
H1
Attach 2 x separated Slide Tracks (H7-1) onto Side Panels (P2) & (P3) with 6 x Screws (H6),
using a Phillips Head Screwdriver as shown.
Pay attention to ensure the Slides are in correct direction as shown.
Screw 8 x Cam Bolts (H1) into Side Panels (P2) & (P3),
using a Phillips Head Screwdriver as shown.
Insert 8 x Dowels (H3) into Side Panels (P2) & (P3) as shown.
Use a Mallet to gently tap the Dowels into place if needed.
fantasticfurniture.com.au
Separate the 4 sets of Slide Runners (H7-2) and
Slide Tracks (H7-1) from Slides (H7) by following the steps below:
Extend the Slide Runner all the way forward.
Press the plastic release lever of the Slide down and
pull the Slide Runner (H7-2) completely out.
H1
H6
H6
H6
H1
(P3)
H3
Slide runner H7-2
Adjust runner to access the screw holes.
H3
H3
H1
H7-1
H7-1
H3
Slide track H7-1
Note the position
of the rubber stopper
H7-1
H1
H1
H6
H6
H6
(P2)
H3
H7
H7-1
H7-1
H3
Page 12
Advertisement
