Page 2
WARNI NG WARNING FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE THAT IS NOT COVERED BY YOUR WARRANTY Lay out all of the components on a soft surface Read Instructions carefully. as if you were preparing to do a jigsaw puzzle. Check no parts are missing.
Page 3
What You Need To Assemble the Body Side Panel(P2) Table Top With Lift Mechanism (P1) (Tools not provided) Phillips Head Screwdriver Flat Head Screwdriver Mallet Bottom Panel(P3) Support Frame(P4) Side Panel(P2) Allen key provided 14 x Cam 14 x Cam Nut 8 x Dowel (H1) (H2)
Page 4
Step 1 (H3) You will need: 14 x Cam bolt (H1) 8 x Dowel (H1) (H3) (P2)x2 Attach each 7 x Cam Bolts (H1) and 4 x Dowels (H3) to each Side Panel (P2). Step 2 This is how a cam nut works..The head of the cam bolt goes into the open mouth of the...
Page 5
Step 3 You will need: 12 x Screw (H5) (P3) x 12 (H5) Screw on the bottom panel (P3) by using screw (H5) as shown. Step 4 You will need: 12 x olt (H4) 4 x Spring Washer (H6) (H7) 1 x Allen key (H6) (H4)
Page 6
Step 5 Turn over carefully. Make sure the top does not open during turning to prevent damage. The job is now complete! In the interest of our environment Please dispose of all packaging thoughtfully Page 6...