McQuay MQS-174018-CFC216A Installation And Operation Manual page 7

3.3 Introduction for buttons on remote controller
3
+/- button
● Press "+" or "-" button once increase or decrease set temperature 1℃ .
Holding "+" or "-" button, 2s later, set temperature on remote controller will
change quickly. On releasing button after setting is finished, temperature indica-
tor on indoor unit will change accordingly. (Temperature can't be adjusted under
auto mode)
● When setting TIMER ON, TIMER OFF or CLOCK, press "+" or "-" button to
adjust time. (Refer to CLOCK, TIMER ON, TIMER OFF buttons) When setting
TIMER ON, TIMER OFF or CLOCK, press "+" or "-" button to adjust time. (Refer
to CLOCK, TIMER ON, TIMER OFF buttons)
4
FAN button
Pressing this button can set fan speed circularly as: auto (AUTO), low(
( ), high(
Note:
● Under AUTO speed, air conditioner will select proper fan speed automatically
according to ex-factory setting.
● Fan speed under dry mode is low speed.
5
button
Press this button can select up&down swing angle. Fan blow angle can be selected
circularly as below:
● When selecting "
louver will automatically swing up & down at maximum angle.
● When selecting " 、
position. Horizontal louver will stop at the fixed position.
● When selecting "
Horizontal louver will send air at the fixed angle.
● Hold " "button above 2s to set your required swing angle. When reaching your
required angle, release the button.
Note:
● " 、 、 " may not be available. When air conditioner receives this signal, the
air conditioner will blow fan automatically.
).
Auto
no display
(horizontal louvers stops
at current position)
", air conditioner is blowing fan automatically. Horizontal
、 、 ", air conditioner is blowing fan at fixed
、
、 、 " , air conditioner is blowing fan at fixed angle.
5
) ,medium