Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual page 146

Page 146 of 302
553-3001-204 Preliminary 0.10 August 2000
Installation and configuration of ITG Line 2.0 node
• Transmitting the node and card properties to Leader 0
• Transmitting card properties to all cards in the node
Procedure 16
Set the Leader 0 IP address
1 Access the ITGL shell by connecting a MAT PC to the RS232 serial
maintenance port on the faceplate of the ITG Leader 0 card with an
NTAG81CA PC Maintenance cable. If required, use an NTAG81BA
Maintenance Extender cable between the PC Maintenance cable and
the MAT PC.
Alternatively, connect the NTAG81BA Maintenance Extender cable to
the female DB -9 connector of the NTMF94EA E-LAN, T-LAN RS232
Ports cable for a more permanent connection to the ITG card serial
maintenance port.
Note: Never connect two terminals to the faceplate and I/O panel
breakout cable serial maintenance port connectors at the same time.
2 Use the following communication parameters for the TTY terminal
emulation on the ITG MAT PC: 9600 baud, 8 bits, no parity, one stop
bit.
3 Login to the ITGL shell and enter the command setLeader to set the
Leader 0 Management LAN IP address, Management LAN gateway IP
address and the Management LAN subnet mask.
Enter the same Management LAN IP address you entered for
a.
Leader 0 in the ITG IP Phones application Configuration tab.
b. Enter the same Management LAN gateway IP address and
Management LAN subnet mask address you entered in the ITG
IP Phones application General tab.
Note: All ITGL shell commands are case-sensitive. The three
parameters must each be enclosed in double quotes. You must put a
space after the command, and before the first parameter, and a
comma and no spaces between the following parameters.
4 Observe the Leader 0 card faceplate maintenance display window:
When the display reads "T:20", it begins to send bootp requests on the
E-LAN. A series of dots appears on the TTY.
5 Type +++ and press Enter.