Safety And Compliance; Part 15 Rules; Class B Digital Device Or Peripheral; Modifications - Polycom SoundPoint IP 500 User Manual

All manuals and user guides at all-guides.com
Display shows "Network Link is Down"
• To check LAN status, press the
Menu key followed by System Sta-
tus and Network Statistics. Scroll
down to see if LAN port shows
Active or Inactive.
• Check the termination at the switch
or hub end of the network LAN
cable. Ensure that the switch/hub

Safety and Compliance

Part 15 Rules

This device is compliant with Part 15 of
the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and

Class B Digital Device or Peripheral

Note: This equipment is tested and com-
plies with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to pro-
vide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can

Modifications

In accordance with Part 15 of the FCC
Rules, the user is cautioned that any
changes or modifications not expressly

Installation Instructions

Installation must be performed in accor-
dance with all relevant national wiring
rules.
port connected to the telephone is
operational (if accessible - other-
wise contact your System Adminis-
trator).
• Reboot the telephone to attempt
reconnection to the network.
2. This device must accept any inter-
ferences received, including inter-
ference that may cause undesired
operation.
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an out-
let on a circuit different from that
to which the receiver is connected.
4. Consult the dealer or an experi-
enced radio/TV technician for help.
approved by Polycom, Inc. could void the
user's authority to operate the equipment.
L'Installation doit être exécutée confor-
mément à tous les règlements nationaux
applicable au filage électrique.
18