Troubleshooting; If You Have A Problem; Lubrication; Service - Hoover F5810 Owner's Manual

If you have a problem

This appliance was inspected thoroughly and was in good
operating condition when it was shipped from the factory.
If a minor problem occurs, it usually can be solved quite
easily when the cause is found. Therefore, this check list is
provided for your convenience.
Possible cause
Machine won't run
1. Not firmly plugged in.
2. No voltage in wall
plug.
3. Blown fuse/tripped
breaker.
Low suction
1. Recovery tank lid not
on correctly.
2. Recovery tank full/
automatic shut-off
engaged.
3. Obstruction in hose
on stair/upholstery
nozzle.
4. Recovery tank front
panel not replaced after
stair or upholstery cleaning.
Clean solution won't dispense
1. Solution tank not
firmly in place.
2. Solution tank empty.
3. Recovery tank lid
not on correctly.
4. Stair/upholstery
solution tube not
securely fastened.
Solution tube on stair/upholstery nozzle won't
connect
1. Connector collar
R4 2-96 F5805/15/17/25/27/31/33
12
Possible solution
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset
breaker.
1. Make sure lid is on
securely (page 7).
2. Remove and empty
recovery tank.
3. Remove hose; clear
obstruction.
4. Replace recovery tank
front panel (page 10).
1. Make sure tank is
securely locked
in position.
2. Refill tank according to
instructions for surface
being cleaned (pages 5 & 6).
3. Make sure lid is firmly in
place.
4. Make sure tube is
securely fastened
at connection of hood.
1. Extend black tabs on
pushed forward.
connector by pulling
collar towards tube.
HOOVER and
THE HOOVER COMPANY, NORTH CANTON, OHIO 44720

Storage

Before storing:
• Empty solution tank and rinse thoroughly with clean
water.
• Replace empty solution tank and turn deep cleaner
ON. Squeeze trigger and push deep cleaner forward
and back several times to expel any solution
remaining in the deep cleaner's system. (Do not use
deep cleaner on wood floors.)
• Empty recovery tank and rinse thoroughly with clean
water.
Allow underside of deep cleaner to air dry thoroughly
before storing deep cleaner on a carpeted or wood
surface.
Do not store deep cleaner with a full solution tank in
place.

Lubrication

The motor is equipped with bearings which contain sufficient
lubrication for the life of the motor. The addition of lubricant
could cause damage. Do not add lubricant to motor
bearings.

Service

To obtain approved HOOVER service and genuine
HOOVER parts, locate the nearest Hoover Factory
Service Center or Authorized Hoover Warranty Ser-
vice Dealer (Depot) by:
• checking the Yellow Pages under "Vacuum
Cleaners- Household" OR-
• checking the list of Factory Service Centers
provided with this cleaner OR -
• calling 1-800-944-9200 for an automated
referral of authorized service outlet locations
(U.S. only).
Do not send your cleaner to The Hoover Company in
North Canton for service, this will only result in delay.
If further assistance is needed, contact The Hoover
Company Consumer Response Center, North Canton,
Ohio 44720 Phone: 1-800-414-1066.
In Canada, contact Hoover Canada, Burlington, Ontario
L7R 4A8, Phone: 1-800-263-6376.
Always identify your cleaner by the complete model
number when requesting information or ordering parts.
(The model number appears on the back of the cleaner
handle.)
are registered trademarks
Litho USA 56518-080