Carpet Cleaning Machine Description - Hoover F5810 Owner's Manual

The easy to use deep cleaner
Hide thumbs Also See for F5810:
Table of Contents

Advertisement

10
15"
16"
16"
Position the remaining straps on the "solution" tube about 16
inches apart. Fasten the straps around the "suction" hose
about every 15 inches to allow for flexibility of the hose
(Fig. 10).
The last strap should be at least 18 inches from opposite end of
hose and tube.
Mounting wall rack
(some models only)
The wall rack, included with some models, is designed to store
the stair/upholstery kit.
11
Hold rack against wall in desired location and mark center of
each hole. Drill a 1/8-inch diameter starter hole in center of
each mark.
If wall rack is being mounted into dry wall, plaster, or thin
paneling backed by dry wall or plaster*, enlarge starter holes
to 13/64-inch diameter. Push plastic anchors fully into holes.
Place rack on wall over anchors. Begin driving screws into
anchors. Tighten securely (Fig. 11).
*Do not attempt to mount wall rack onto thin paneling without a
dry wall or plaster backing.
If wall rack is being mounted onto a wall stud, solid wood, or
thick paneling, drill only the starter holes. Place rack onto the
wall and drive screws into holes without plastic anchors (Fig. 11).
12
BARE
FLOOR
TOOL
Hang hose on rack as shown (Fig. 12).
The bare floor cleaning tool (included with some models) can be
hung in center of rack as shown (Fig. 12).
4
Assembly - Carpet cleaning machine description
NOZZLE
15"
3"
HOSE
SOLUTION
TUBE
HOSE
Carpet cleaning
machine description
The assembled carpet cleaning machine will look like the
drawing below.
1
4
14
13
1.
Hand grip
2.
Solution trigger: press to release clean solution.
3.
Cord hooks: wrap cord around hooks for storage.
The top hook can be rotated right or left for quick and easy
cord release.
4.
Carrying handle
5.
Clean solution tank handle
6.
Clean solution tank cap/ measuring cup
7.
Clean solution tank: holds cleaning solution.
8.
Recovery tank lid
9.
Recovery tank: holds dirty solution.
10. Recovery tank "front panel"
11. Hood
12. Nozzle
13. Upholstery and stair cleaning connection (some models
only): push door open to connect stair/upholstery tool
"solution tube".
14. Recovery tank latches: one on each side of tank.
15. ON/OFF pedal
16. Handle release pedal: step on pedal to lower handle
to operating position.
This carpet cleaning machine is intended for household
use.
5
6
7
8
9
10
11
14
12
2
3
3
16
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fh50020SteamvacSteamvac f5805

Table of Contents