Sabaj K-DOWN Assembly And Operating Manual page 26

K-DOWN
3. Troubleshooting: The table of symbols on the digital display should also be used as a
troubleshooting guide. Always check, if the green POWER led light is on – this signals,
that the control box is powered. When you put the plug to the socket, you will hear the
beeper sound, and the green led will be turned on. If the LED is not on, the problem might
be with the control box fuse breakdown, or there is no power in the socket.
Display Explanation
Solution
Assigning RF remote to
Press any button on RF remote to assign, or
control box
wait 15 seconds to quit mode
Assign IR remote to control box
Press I and II consequently to program
Check all the connections and contacts from Lift to
LIFT Limit switch cable
control box. Some pins might be loose due to
harness disconnected
transport of furniture fitting
UP VP Memory approved -------
LITF electric motor overload Lower the LIFTs load
Check all the connections and contacts from LIFT
LIFTs wiring disconnected
wiring to control box. Some pins might be loose
due to transport of furniture fitting.
The LIFT motor might be blocked mechanically ,
unable to start moving. Cables might be loose.
Many reasons to this error – please contact
No impulses from LIFT's Motor
Sabaj support, providing photos of the
installation.
Full motion reset -------
helpdesk@sabaj.pl
26