VALBERG WF 1014 B AID W180C Instructions For Use Manual page 17

B B
Using the appliance Utilisation de l'appareil
Time Save button again. After the program starts,the indicator ligbt is always on.
This function is only added under the standby state of its applicable program, that is, before
the program is started. After the program is started, the function cannot be selected.
After tbis function is selected, the determined main washing time will be reduced by 15 mins.
Inlet water warning
If tap is not opened, or water pressure is over low, inlet water fault icon will display, and
display screen will prompt "F01 " to give alarm.
Drainage warning
If the pipe is squeezed, drainage will not be smooth. In case of failing to completely drain for
long time, drainage fault icon will display, and display screen will prompt "F03" to give alarm
Door Lock Icon
After the program starts the Door Lock icon will light up and the door will be locked.
After completing program, door lock unlocks automatically. During pause, if door opening
condition can be met halfway, the door lock will unlock and its indicator light will go out.
When door lock indicator light flashes, door shall not be opened forcibly so as to avoid personal
injury.
Delay End Function
Delay End function allows to run the machine at the consumers' convenience, for example,
at night when electricity is cheaper.
• Only under the standby mode, this button is valid for selecting the reservation time.
• After the reservation function is selected, the time will increase lh when each time the
reservation button is pressed. Before reservation, if the program time does not satisfy the
integral multiple of lh, it shall be completed by pressing the reservation key for the first
time, and then the time increases lh when each time the reservation button is pressed. If the
reservation is selected, before the program runs, the current reservation can be canceled
by turning the button to select other programs.
• The delay time must be longer than the wash program length as the delay time is the time
program will finish. For example: if the selected program time is 02:28, the delay time selected
must be between 03:00 and 24:00.
• When the reservation process is operated, the icon of 'reservation time' will be on. When
the reservation process startup, the icon of 'reservation time' will flash.
30 30 EN FR
B B
Using the appliance Utilisation de l'appareil
• Long press the Delay End button,the reservation time jumps fast.
Favourite
1. Press the "On/Off "button to tum on the machine;
2. Select the washing program;
3. Select parameters(washing temperature ,spin speed,etc);
4. Press Favourite button for 3 seconds;
5. Favourite is stored(only one program can be stored},select Favourite when using tbis
program,press "Start / Pause"to start;
6. When the user uses it for the first time, ifhe/she has never long pressed the Favorite button
to collect programs, he/she can short press the Favorite button and then the cotton linen
program and its default settings will be collected by default;
7. Short press Favourite button,then the symbol is on. Repeat the same operation or press
other buttons to exit this program, the symbol is off;
8. After selecting other functions, long press 3 seconds to override the original program.
Mute Function
When the machine is in the state of holding, pause or operation, press "Spin+Favourite"
buttons for 2 seconds, the Mute icon will light up. All the buzzing will be turned off except the
alarms. When the machine is in the mute state, press "Spin+Favourite" buttons for 2 seconds,
the Mute icon will turn off. All the buzzing will be activated.
Softener detergent release
1. Select to turn on or off softener/detergent release and set the release volume;
2. It is active in the standby mode. After this key being pressed, the softener/detergent volume
will be selected in a cycle mode in accordance with Automatic: -Large -Medium -Little -off;
3. The softener/detergent release selection will be memorized, that is, after selection and
operation by the user, the release volume for the next time will be that of selected in the
last time;
4. When the user uses the machine for the first time, it is defaulted that the softener/detergent
release is turned on and the release volume is automatic;
5. When the softener/detergent release is turned on, if it is detected that the amount of softener/
31 31 EN FR